Occasionally, especially with newly gripped or new clubs, the grip will fall off with no tape residue within. However, if there is still tape in there, I use the bore cleaner to scrape it clean. This procedure is aided by a bit additional solvent in the grasp. That's the only thing there is to it. It is not suitable for Winn or cord grips, according to GolfWorks and Golfsmith.
There are several different methods used to remove tape from wood. The most effective method depends on how much damage has been done to the wood by the tape. If the wood is still sound, I usually soak the club in a mixture of alcohol and water for a few hours then scrub the tape off with a stiff brush and some more alcohol. This process removes the majority of the tape without damaging the wood.
If the tape has damaged the wood too much for repair, I usually just cut the tape out. This can be difficult if the tape has stuck to the face of the club firmly; you may need a saw to do this job properly. In this case, try not to cut into the wood around the tape or you might have to replace it later.
Tape can also be removed using chemicals. There are two types of chemicals commonly used for this purpose: removers and breakers. Removers are designed to dissolve both rubber and vinyl tape while breakers are specific tools used to break down metal tape. Neither type of chemical is recommended for use on wooden instruments because they could leave a residue that would cause further problems with string tension.
Grip solvent aids in the removal of residue from old grips and facilitates the installation of new grips. However, the solvent is hazardous, and several substitutes can be employed. Old grips must be cut and removed from clubs, but the grip tape below might be difficult to remove.
Golf grips tend to mold over time due to exposure to heat, moisture, and dirt. This makes it difficult to install new grips. The easiest way to install new golf grips is to first soak them in a solution of water and white vinegar for 30 minutes to an hour, then wash them with soap and warm water. Let them air-dry before using your club.
If you don't want to go through the hassle of removing old grips, there are other options available. You can use a chemical stripper to soften the adhesive that holds the grip in place, then peel it off. Or you can use rubber cement to attach new grips, but be sure to let them dry completely before using your club.
As long as you avoid chemicals and solvents when cleaning your golf equipment, it should keep running smoothly for a long time after its original manufacture date.
Obtain a spring-loaded grip remover. Many golf equipment manufacturers sell them to help in the removal of outdated grips from clubs. An adhesive-removing solvent, such as paint thinner or acetone, will also be required. Put the solvent in a squeeze container for easier application. Let the club sit in the solvent for several hours until the glue is completely removed.
Golf grips are used to protect the face of the club while not in use. They can get worn out over time, however, which will affect how well your club swings. If you'd like to change the look of your club without buying new equipment, consider painting or staining the grip a new color.
Golfer's hands are always wet during play, so waterproofing the grip is important. There are two types of golf grip weatherproofing: latex and acrylic. Latex covers apply easily with a brush or sprayer and dry quickly. Acrylic requires immersion in a bathtub full of hot water for up to an hour. Both types of material are available in a wide range of colors. Before applying any type of sealant, make sure to wash your hands thoroughly with soap and water afterwards.
Latex and acrylic seals can be re-applied if needed, but unlike paint, they cannot be removed completely. This means that if you want to change the color of the grip, you'll need to start again from scratch.